Operation Manual

13 • EN
Return to contents
Charging the internal battery
Although Snooper can be charged using the cigarette lighter in your vehicle, an
alternative method of charging is either a USB socket of a PC or USB Mains charger
(output of 5v 1000mA) - not supplied.
The battery light on Snooper will illuminate and will take approximately 3 hours to
charge. When the internal battery is fully charged, the red LED will switch turn blue.
Note: The new battery’s full performance is only achieved after two or three
complete charges and discharges.
Powering Snooper using the built-in battery
Once Snooper is fully charged, it is ready for use. Press and hold the standby/power switch on the top left hand side of the unit for 2
seconds to switch on the device.
On Battery - No LED
On Charge - RED
Fully Charged - Blue
ON/OFF
switch
Plug the
charger cable into
the USB socket on the
left hand side
of the Snooper