Operation Manual

14
3. S6-RLD External Installation
As the S6-RLD is waterproof it can be mounted outside the vehicle with
the ’L’ shaped bracket, water resistant double-sided tape and screw pack
provided.
- Find a suitable mounting position for the detector, ensuring that the front
of the unit has a clear view of the road ahead and is unobstructed by any
metallic objects and that there is a sufficient mounting area to attach the
’L’ shaped fixing bracket. The S6-RLD needs to be mounted in as
horizontal a position as possible so that it is looking directly down the
road ahead but can be mounted either flat or on it’s side if necessary.
We recommend that you mount the detector either behind the vehicles
grille (If the openings of the grille are at least 10mm in diameter) or within
an air intake at the front of the vehicle. The S6-RLD can be mounted
anywhere at the front of the vehicle, but for optimum performance we
suggest you mount it as close to the number plate of the vehicle as
possible.
- When you have found a suitable location, using the ’L’ shaped mounting
bracket as a template, drill between 2 and 4 pilot holes into the selected
mounting surface for attaching the bracket using either the self-tapping
screws or the nuts and bolts provided.
You will need to attach the bracket using
at least 2 screws or 2 nuts and bolts to
ensure that the bracket is well secured.
Remember that there is a lot of
vibration within the engine bay
so it is very important that the
S6-RLD mounting bracket is
secured correctly.
Typical Fitting
10mm
Minimum
Typical Fitting
23
and press the button below ’Select’ (5).
Then using the buttons below the
arrows on the display, highlight your
desired setting, either ’ON’ or ’OFF’.
Once you have made your choice
press the ’Select’ button. If you are
turning the setting ’ON’ the screen
will either display a factory default
speed or your previous speed selection.
Use the arrows to increase or decrease
the speed to your desired setting and press ’Select’. The screen will read
’SETTING CONFIRMED’ to confirm your selection and will return to the
Menu screen.
Note: To return to the Menu screen from the Sub Menu screen, press the
button below ’Back’ (2) on the display. To return to the Standby screen from
the Menu screen press the same button, which will now say Cancel . If no
buttons are pressed on the device for a period of five seconds the screen
will automatically return to the Standby display.
Please note that there could be a satellite delay of one or two seconds,
therefore the speed indicated by the device may be different to your
actual speed. Always check your speedometer for confirmation of your
vehicles speed.
5. Speed measurement type
This feature allows you to select between MPH and KMH. The device
comes with MPH turned on as the factory default setting. To change this
setting, please refer to the following instructions.
From the Standby screen press the
button below ’Menu’ on the LCD
display and then using the buttons
below the Up (3) and Down (4)
arrows, scroll the display until ’
SPEED MEASURE is highlighted
and press ’Select’ (5). Then using
the buttons below the arrows on the
display, highlight your desired setting,
either ’MPH’ or ’KMH’. Once you have
made your choice press the ’Select’ button.
The screen will read ’SETTING CONFIRMED’ to confirm your selection
and will return to the Menu screen.
Note: To return to the Menu screen from the Sub Menu screen, press
the button below ’Back’ (2) on the display. To return to the Standby
screen from the Menu screen press the same button, which will now say
Cancel . If no buttons are pressed on the device for a period of five
seconds the screen will automatically return to the Standby display.
2 3 4 5
SPEED : 30MPH
SUB MENU
2 3 4 5
MPH
KMH
BACK
SELECT
BACK
SELECT
SUB MENU