Operation Manual

42
Return to contents
5.4
S7000 comes complete with a comprehensive list of POI’s (Point’s of
Interest). You can search for addresses using POI’s and save POI’s in your
list of favourites. You can also choose which of the POI’s you would
like to have indicated on your map. As standard ALL POI’s are shown,
however this list can be edited within the POI Menu.
l Press the centre of the screen to enter the ‘Navigate to’ menu.
l Press the ‘Configure’ button.
l Press the ‘Show POI’ icon.
The screen will now show a list of POI’s stored on your unit with a ‘tick’
box to the left of each type of POI. Simply press the tick box to select or
deselect the POI. A red tick in the box indicates that the POI will appear
on your map, an un-ticked box will remove the POI from the map view.
To scroll through the list of POI’s you can press either the up or down
arrows located on the right hand side of the display.
To deselect all POI’s from the map un-tick the ‘ALL’ tick box at the top of
the list of POI’s
To save the changes press the ‘OK’ button at the bottom of the display.
If you wish to exit the ‘Show POI’ list without saving any changes
press the return arrow located in the bottom right hand corner of the display.
5.5
Auto Scale is switched ‘On’ by default during manufacture. Auto
Scale automatically magnifies the map as you approach a junction or
roundabout, where you may need to make a turning, so that you can
see it in more detail.
Auto Scale can be turned on and off as you wish. To change this
setting:
l Press the centre of the screen to enter the ‘Navigate to’ menu.
l Press the ‘Configure’ button.
l Press the ‘Auto scale’ icon.
The screen will now show two options ‘ Ye s’ and ‘No’. To make your selection, touch the relevant tick box with your finger.
To save the changes press the ‘OK’ button at the bottom of the display.
If you wish to exit the ‘Auto scale’ menu without saving any changes press the return arrow located in the bottom
right hand corner of the display.