Operation Manual

9
Return to contents
Start Up – Installing the SD Card
Before using the S7000, you will need to install the SD Card included with the device.
The SD Card comes complete with digital mapping and is also where the AURA™
camera database is stored if you choose to subscribe and download it.
Start by moving the ‘Batt. ON/OFF’ switch located on the back of the unit to the ‘ON’
position, then remove the SD card from its packaging and insert it into the SD Card
slot as indicated. Switch on the device by pressing and holding the standby power
button located on the side of the unit for 2 seconds. Press the ‘Navi’ icon. When the
‘Navi’ icon is pressed the S7000 will automatically synchronise with the SD Card. Once
the synchronisation is completed, the SD Card will not function with any other device.
S7000 is now ready to navigate and the camera database can be downloaded if
necessary.
Please note that if the unit does not activate when you press and hold the standby power button for 2 seconds it may
require charging. Refer to the section ‘Charging the internal battery’ later in this manual.
System Requirements and Downloading
Before you can begin to download the database onto S7000, you will need to install the S7000 Updater software provided on the CD
ROM.
In order for the software to be installed successfully, there are certain minimum hardware and software requirements needed.
Hardware Requirements
The computer must have an Intel Pentium Class processor or equivalent, a minimum of 32MB of RAM, a monitor with 256 (8-bit)
colours or greater, a CD ROM drive, 20MB of free disc space and a spare USB connection.
Software Requirements
The software will only operate on the following Windows based operating systems:
Windows 2000
Windows XP (32 bit)
Windows Vista (32 bit)
and, in addition, will only work with Internet Explorer 6 or Netscape Navigator 6 or above.
NOTE: S7000 Updater software does not support Windows 95, 98, Millennium or Apple Macintosh operating systems.
Windows XP and Vista (64 bit) systems are also not supported.
Software Installation Instructions
Place the Software CD into a CD ROM or DVD drive. Your PC should automatically open a window displaying the instructions for
installing the software. Follow the instructions onscreen to install the download software.
To launch the CD manually: Click on ‘Start’ and then ‘Run’. In the dialogue box that opens click on ‘Browse’ – another dialogue box
will open. Locate your CD ROM or DVD drive (drive letter is normally D) using the ‘Look in’ option and select ‘Menu’ from the lower
portion of the dialogue box. Once you have selected ‘Menu’ click on ‘Open’ on the explorer box and then ‘OK’ on the Run dialogue
box.
Please make sure that the operating system installs the new hardware first before installing the Updater software. Once the updater
software has been installed click ‘Finish’ and then close the CD auto run window. After installing the software, click ‘Start’ then ‘All
Programs’ and select the updater program to start it. Select your ‘Language’, ‘Vehicle Type’ and ‘Download Settings’ when prompted.
Any later download software updates can be obtained from www.snooperneo.co.uk. If you have any problems using this software
please call 0870 787 0700 during office hours and select Option 3.
Once the software is installed, you are ready to download the database onto S7000. Once the initial setup is completed the
updater software runs automatically in the background. This is indicated by the symbol
or , which is located in the
system tray in the bottom right hand corner of your desktop near the system clock.