Operation Manual

13 • UK
Return to contents
Plug the charger into a
240V AC mains socket
Charging the internal battery
Although S7000 can be charged using the cigarette lighter in your vehicle, a
complete charge is more easily achieved by using the 240V AC mains charger
included. When new, the battery contains a nominal charge.
To charge the unit fully, move the ‘Batt. ON/OFF’ switch to the ‘ON’ position and
connect the 240V AC mains charger as indicated in the picture on the right. The
battery light on S7000 will illuminate and will take approximately 3 hours to charge.
When the internal battery is fully charged, the red LED will switch OFF.
Note: The new battery’s full performance is only achieved after two or three
complete charges and discharges.
Powering S7000 using the built-in battery
Once S7000 is fully charged, it is ready for use. Ensure the ‘Batt. ON/OFF’ switch is in the ‘ON’ position and press and hold the standby/
power switch on the left hand side of the unit for 2 seconds to switch on the device.
Plug the
charger cable into
the socket on the
side of the S7000
ON/OFF
switch
1. Main menu will appear after startup screen is
briefly displayed
2. Execute your preferred application by
touching the relevant icon.