Replacement Part List

9
30SB, 36SB, 45SB
Snow BEAST
Snow BEAST Snow Blower
Rev Jan 2016


1. Align the two holes on each side of the control panel
handles over the lower handle frame.
2. Insert the bolts through the handlebar holes and frame
holes. Secure in place with hardware provided. All bolt
heads must face to the inside.
3. Connect the headlight wring harness to the engine
Wiring
harness.

Aach the cable coming from the middle of the
control panel by screwing the cable end onto the
crank secon.
Bolt installed boom-up

---

1. Fit round spacer onto impeller housing before
installing chute.
2. Install the bolts for the retainer brackets boom-up as
shown. Insert the plasc spacer between the two
metal parts.
DO NOT OVERTIGHTEN. If the bracket is too ght the
chute will not move properly. Ensure there is enough
space between the impeller housing and the bracket on all
sides so that the chute rotates smoothly.