Replacement Part List

19
30SB, 36SB, 45SB
Snow BEAST
Snow BEAST Snow Blower
Rev Jan 2016


If tension seems to be too loose or too ght the
drive
cables needs to be readjusted.
1. Loosen the bolt above where the cable screws
in
to the right side of the control panel.
2. Loosening the bolt en-
ables the cable to
screw in
further, which makes
the augers/impeller
handle ghter.
3. Adjust the bolt and
cable to the necessary
adjustments.

If tension seems to be too loose or too ght the
augers/impeller cables needs to be readjusted.
1. Loosen the bolt above where the cable screws
in
to the le side of the control panel.
2. Loosening the bolt en-
ables the cable to
screw in further, which
makes the augers/
impeller handle ght-
er.
3. Adjust the bolt and
cable to the
necessary adjust-

The shi rod will be at a preset posion from
the factory, but aer use, or maintenance, the
shi rod may require occasional adjustment.
Signs of adjustment need:
1. The shi handle is moved to the F1 posion,
and when the engagement handle is
pressed, the unit does not move.
2. The shi handle is moved to the R1 posion,
and when the engagement handle is
pressed, the unit does not move.
If either of the above occur, it may be necessary
to adjust using the following procedure:
1. Set the transmission handle to the space
between F1 and R1 as shown on the right.
2. Loosen the 2 nuts on the adjustment
turnbuckle.
3. Remove the cover plate from the gearbox
housing (see page 22).
4. Adjust the rod by turning the turnbuckle unl
the fricon wheel aligns with the center of the