Replacement Part List

21
30SB, 36SB, 45SB
Snow BEAST
Snow BEAST Snow Blower
Rev Jan 2016

The discharge chute is preset at the factory, but
may require adjustment over me or during
maintenance.
For adjustments, follow the procedure below:
1. Loosen the two nuts at the chute cable mount
on the discharge chute.
2. To make the chute open more, adjust nuts so
the cable end moves closer to the discharge
deector (upward).
3. To make the chute close more, adjust nuts so
the cable end moves further from the


If the fricon wheel needs to be replaced for any
reason:
1. Remove the two bolts to remove the cover
underneath the control panel between the
wheels.
2. Remove the bolt and nut in the hexagonal
sha carrying the fricon wheel
3. With the bolt and locking nut removed, the
sha can be removed with the rubber fricon
wheel assembly.
4. Replace the fricon wheel and reassemble in
reverse order.
5. Reseng the neutral posion may be
necessary.
Replacement fricon wheel rubber is available for

1. Push the headlight case up from the
boom, then gently li the headlight out.
2. Twist the black round wire harness counter-
clockwise unl the bulb is unlocked at the
spot.
3. Replace the bulb and lock the headlight back
into place the same way it was taken out.
Replacement bulbs are available for purchase