Owner's manual

4. Remove the old paddle auger from the housing (Fig. 11).

5. To install the new paddle auger, place the washer (A) back

onto the bolt (removed in step 1) and insert the bolt so that

it protrudes slightly into the housing of the unit. Thread the

nut and then the other washer (B) onto the bolt. Fit the new

auger onto the end of bolt and tighten the bolt (Fig. 12).

6. Reinstall the big pulley plate (Fig. 10) and align it with the

other end of the auger. After tting the auger into position,

secure the big pulley plate with the three (3) screws

(Fig. 13).

NOTE: The housing will ex to allow for installation of the

new paddle auger.

7. Place the tensioner back into position. Rotate the auger to

ensure that the belt and auger move freely, then reinstall

the cover by securing it with the seven (7) screws

(Figs. 14 & 15).

mWARNING! Do not power the unit until the cover guard

is securely in place to prevent damage or injury.

Replacing the Belt

mWARNING! Disconnect the power from the electric

snow shovel before performing this task.

1. Disassemble the left side cover by removing the

seven (7) screws (Fig. 9).

2. Remove the tensioner (Fig. 16).

3. Unscrew the three (3) screws from the big pulley plate and

the four (4) screws from the small pulley plate (Fig.16).

4. Replace the worn belt with a new belt.

Fig. 11

Fig. 12

Washer (A)

Nut

Washer (B)

Bolt

Fig. 13

Fig. 14

Tensioner

Big pulley plate

Fig. 15