Replacement Part List

11
NOTE: If the top light remains green while the bottom light
alternately ashes red and green, this indicates a temperature
abnormality (i.e. that the battery pack is either too hot or too
cold). If there is only a red blinking light, this indicates that
something is wrong with the battery. Contact Snow Joe
®
+
Sun Joe
®
customer service center at 1-866-SNOW-JOE
(1-866-766-9563) for assistance.
4. A fully discharged pack with an internal temperature in
the normal range will fully charge in 5 hours (between
32ºF/0ºC and 113ºF/45ºC). Heavily cycled battery packs
may take longer to charge completely.
5. If the charging light indicator alternately blinks red and
green or the light indicator does not come on at all, check
that the battery pack is fully seated into the bay. Remove
the pack and reinsert. If the problem persists, contact the
Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563) for assistance.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger (Fig. 10).
7. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
Charging a Hot or Cold Battery Pack
A red and green ashing indicator light on the charger
indicates that the battery pack temperature is outside the
charging range. Once the pack is within the acceptable
range, normal charging will take place and the red light will
be continuous. Hot or cold battery packs may take longer to
charge.
Controls + Features
m
WARNING! AVOID INJURY. Read and understand the
entire safety section before proceeding.
Snow blower controls and features are described below and
illustrated on page 7.
Control Panel (Fig. 11)
1. Forward Button – There are 3 forward speeds. Press
for a slowest speed and press
for a fastest speed.
2. Reverse Button – Press
reverse button to control
reverse travel.
IMPORTANT! DO NOT change motion from forward to reverse
with trigger engaged.
3. LED Light Button – Press
to utilize the LED lights
for nighttime snow removal.
4. Battery Light Indicators –
The battery is at full capacity.
The battery is at 60% capacity.
The battery is at 30% capacity.
5. XPORT button – Press
for rapid return when the
job is done.
NOTE: The auger will not engage when in either REVERSE or
XPORT mode.
Green
Flashing red/green
Temperature abnormal
Flashing red only
Something is wrong
Fig. 10
Push lock button
Battery Pack
Temperature
Lithium-Ion Charging Status
Too hot Flashing Not charging
Normal range Continuous Normal charging
Too cold Flashing Not charging
Red Charger
Indicator Light
Charging
Status
Fig. 11
Speed 1 Speed 2
Transport Reverse LED Lights
Speed 3
Battery 1
indicator
light
Battery 2
indicator
light