Operator`s manual

Assembly
1. Before attempting to assemble, empty carton and
compare parts with packing list on page 2.
NOTE:
• Carefully remove the parts from the box.
• Inspect the parts to make sure no breakage or damage
occurred during shipping.
• Do not discard the packing material until all parts are
examined.
• If any parts are damaged or missing, please call
1-866-766-9563 for assistance.
• Be sure to tighten the knobs when assembled to
prevent the handle from rocking.
Assembling the Handle (Fig. 1)
NOTE: Do not completely tighten knobs until assembly
is completed.
1. Lay handles at on ground.
2. Insert the two lower handles into the middle of left and
right top handles.
3. Secure with two carriage bolts and knob provided, but
not tighten knobs.
4. Attach the right top handle to the left top handle using
one carriage bolt and knobs provided, then make sure
that all the handles are still at on ground.
5. Tighten all the knobs on the joints of the handle
assembly.
Attaching the Handle to the Mower Base
(Fig. 2)
Align holes at the lower end of each handle arm with posts
extending from the mower base side plates. Slide lower ends
of handle arms onto posts. (NOTE: Press arms inward and slip
on posts)
Assembling and attaching the rear bag
(Fig. 3 & Fig. 4)
1. Assemble the bag onto the frame.
2. Place the completed rear bag and hook onto the roller
bar end shaft. (Fig. 3)
3. Place locking strap from the rear bag to the center bars
of the middle handle, adjust strap for proper height
so the bag does not rub the ground while mowing or
transporting. (Fig. 4)
Fig. 1
Fig. 2
Fig. 3
3
Post
Handle bars
Fig. 4