User Manual

8 — 26

Operating the Spreader

SP-2400 INTERIOR BAFFLE and INVERTED-V INSTRUCTIONS

• The SP-2400 uses a multi-function bae system over the auger area.

. This twin bae design is used to reduce load on the auger drive train which controls amperage load to the electrical

system.

It must not be removed unless servicing the unit.

• WARNING: Always disconnect power source before attempting to

remove material bae.

• There are two covers provided, one long and one short. They can be removed in dierent combinations depending on the

material type or moisture content. Ultimately they aid in controlling material ow to the auger area; however for wet sand

both baes should be removed.

. The bae system is also connected to the vibrator link arm assembly to assist with material ow. Make sure vibrator

bolts and link arm hardware are tight before operating spreader.

Short Bae

Long Bae

Connect To Link Arm

Model # SP-2400