Owners Manual User Manual

10 © TrynEx International 2014 F51537 REV-A141205
Troubleshooting
Spreader
PROBLEM POSSIBLE CAUSE SOLUTION
Motor doesn't run Loose electrical connections Check all connections
Motor seized Replace motor
Material not owing from hopper Hopper is empty Fill hopper
Material is wet Replace with clean, dry, free-owing mate-
rial
Frozen material Replace with clean, dry, free-owing mate-
rial
Coarse material Replace with clean, dry, free-owing mate-
rial
Auger loose on shaft Align/Tighten Coupler
Tighten bearing
Vibrator not working Check connections
Replace vibrator
Chute in up position Check/repair mechanical connection
Check/repair electrical connection
Bad actuator. Replace
Material free ows Chute in down position Check/repair mechanical connection
Check/repair electrical connection
Bad actuator. Replace
Poor spread pattern Spinner ns Adjust spinner ns