Instruction Manual

Operating the Spreader (continued)

Model # SP-7550

DISCHARGE BAFFLE and INVERTED-V INSTRUCTIONS

• The 7550 uses an Inverted-v design over the auger area. This

inverted-v (D5510) is used to reduce load to the auger drive train. It

must not be removed unless servicing the unit.

• WARNING: Always disconnect power source before attempting to

remove material bafe.

• The 7550 uses a discharge bafe (D5517) to reduce material

leakage. It must not be removed unless servicing the unit.

• BAFFLE EXTENSION INSTRUCTIONS

• The Bafe Extension (D-5503) is intended to be used with very dry

products that free-ow with little effort. The bafe is designed to

keep these types of materials from leaking out.

• If you plan on using damp/wet materials, you should remove this

bafe by removing the self-drilling screws.

• If you are using a sand/salt mixture, remove bafe extension.

D5510

D5517

D5503