User Manual

VM4 — 26

Operating the Spreader

BAFFLE INSTRUCTIONS

• The V-Maxx 8500 uses a dual bae design over the auger area.

This bae (D6809) is used for dry bulk materials. The bae is

designed to reduce the risk of leakage with clean/dry free-owing

materials. If the material you are using is damp/wet, you may need

to remove bae (D6809). This will allow for more unrestricted ow

of materials and possible bridging.

• WARNING: Always disconnect power source before attempting to

remove material bae.

• The main bae assembly (D 6808) MUST

never be removed from

its original factory installed position unless the unit is being

serviced or the Optimum Flow Kit is being installed.

BAFFLE EXTENSION INSTRUCTIONS

• The Bae Extension is installed at the time of assembly. The main

purpose of this bae is to keep dry, free-owing material from

leaking out.

• If you plan on using damp/wet materials, you should remove this

bae by removing the self-drilling screws.

• If you are using a sand/salt mixture, remove bae extension.

D6809

Key Part No. Description Qty.

D 6847 Salt Bae Extension 1

D 6807 Discharge Bae 1

D 6874 #14 x 1-1/2" TEK w/Neo Washer 2

Model # SP-8500