Datasheet

ManualsBrandsSNT Sensortechnik ManualsSensorsMiniature Ultrasonic Distance And Proximity Sensor 0mm 150mm 4 ... 20 mA

SONARANGE UPS 09.16 e

This Information corresponds to the current state of knowledge. SNT reserves the right to make technical changes. Do not use these products in any application

where failure of the product could result in personal injury. Liability for consequential damage resulting from the use of SNT products is excluded.

SNT Sensortechnik AG, Hammerstrasse 6, CH-8180 Bülach, Switzerland, Phone +41 44 817 29 22, Fax +41 44 817 10 83, info@sntag.ch 1/5

www.sntag.ch

Miniature ultrasonic distance and proximity sensors

UPS Series

Technical specifications UPS 200 …

UPS 200 TVPA 24 C

UPS 200 TOR 24 CA

UPS 200 TOR 24 CI

Detection and adjustment range

20...200

Blind range (no reasonable analogue output signal)

Hysteresis

≤1

Linearity of analogue output

%FS

Reproducibility

%FS

<0.5

Temperature error

%FS

≤1.5

Operating frequency

kHz

~400

Status indicator

LED yellow/red

Binary output, reversal polarity protection

PNP NO/NC

max. 0.1A

Switching speed max.

binary output

~30

Analogue output in detection range

min. 1k with V output

max. 300 with mA output

0...10

4...20

Power supply (reversal polarity protection)

VDC

10...30

15…30

10…30

Power supply ripple

Mean consumption, switched without load

~30

Ambient temperature during operation

°C

0...+70

Mass

Protection class

IP67

Housing material

nickel plated brass

Electrical connection

connector M12, 4-pin

Description

The ultrasonic sensors of the UPS series are particularly

small, and they have a narrow detection beam. Thus they are

well suited to detect objects in the near range up to 150 or

200mm and under confined conditions. The sensors are

available as well as pure proximity switches as also as

distance sensors with analogue mA or V output. The switch

or measuring distances can be learned by a teach-in

procedure. An optional Teach-In box is available. Typical

applications are detection of objects and distance and level

measurement.

 Measuring range up to 200mm

 Very small blind range

 Narrow detection beam

 Small size M12x1

 Teach-In

 Binary or analogue outputs

 Special versions with particularly narrow beam or

chemically resistant

 Measurement independent of material, surface,

colour and size of target

 Work under dust, dirt, fog, light

 Detect transparent and bright objects

download data sheet on

your smart phone with

a QR-Code scanner app.

UPS 200

UPS 150 FB

UPS 150 CP

Summary of content (5 pages)

PAGE 1
SONARANGE UPS 09.
PAGE 2
SONARANGE UPS 09.16 e Window operation NC  Place the object to the near switching point  Teach switching point with +UB  Place the object to the far switching point  Teach switching point with -UB Switching point NO  Place the object to the switching point  Teach switching point with +UB  Cover the sensor diaphragm by hand or let the sensor look into the void  Teach with -UB Model selection The UPS versions have different outputs.
PAGE 3
SONARANGE     Place the object to the lower measuring limit (i.e. where 0V or 4mA is expected) Teach lower measuring limit with –UB Place the object to the upper measuring limit (i.e. where 10V or 20mA is expected) Teach upper measuring limit with +UB Lower and upper measuring limits can also later be programmed individually. The teach wire must not be connected during normal operation. The sensor can e.g. be operated after teaching with a 3 wire cable.
PAGE 4
SONARANGE UPS 02.16 e Special miniature ultrasonic distance and proximity sensors UPS FB und UPS CP Series UPS 150 FB … UPS 150 CP …             Very narrow detection beam (FocusBEAM) Particularly for level measurement in narrow cavities No blind range Measuring range up to 150mm Teach-In Binary or analogue outputs Technical data (rest same as UPS 200...
PAGE 5
SONARANGE Dimensions 70 41 M12x1 M12x1 Stecker/connector UPS 200 ... UPS 02.16 e object itself. No disturbing objects must be between the sensor and the target within the cone. Otherwise the sensor would detect the disturbing object instead of the desired target. Below the typical cone shapes for the UPS sensors are shown. Furthermore, the size of the detection beam is influenced by air temperature and humidity. The colder and dryer the air, the larger is the beam.