User's Manual

Page: 19
Soapy Care Ltd.
Scheme E: Connecting the water supply hose to the ECO-02
5) Unscrew the plastic plug from the unit water inlet.
6) Put a teflon tape on the pipe thread of the unit.
7) Connect the second side of the water hose, the shorter one, to the water inlet on the product.
8) Tighten hose nuts by hand. In case of water leakage, use an open key and gently tighten the nuts.
9) Fully open the tap after making the hose connection to check for water leaks at the connection points. If
any leaks occur, turn off the tap and remove the nut. Put a teflon tape on the leaking pipe thread, retighten
the nut carefully after checking the seal. To prevent water leakages and damages caused by them, keep the
taps closed when the ECO-02 device is not in use.
The water supply pressure must not exceed 3.9 bars (56.6 psi). Attach a pressure reducing valve if
water pressure is higher.
The water supply pressure required to properly run the product is between
1.5-2.45 bar (21-35 psi).
Ensure that the cold water connection is made correctly when installing the product. Do not connect
the hot water to the unit water inlet.