User's Manual

- 22 -
General Operating Instructions
Turning the Device ON or OFF
1. Pivot the screen downward until a comfortable viewing angle is reached.
2. Pressing the POWER button on the lower-left corner of the front panel or the remote control will
turn the device on or off. When in use, the controls will be lit.
3. After the device has been turned on and is displaying a picture, adjust the viewing angle by pivoting
the screen to optimize the picture quality.
4. Remember to turn the device off and pivot the LCD panel to the licked position when not in use.
Channel Tuning Setup (If TV mode is available)
In order to easily access all available TV channels, it may be necessary to perform channel auto-
programming whenever the vehicle’s geographic location has changed i.e. city to city, weak signal area.
1. Press the AUTO MEMORY button on the remote control unit or the AUTO PROGRAM button on
the drop-down video unit. You will see the TV cycling through all its channels. The built-in
microprocessor will automatically note each channel that is actively broadcasting in your area.
2. (A) To tune only strong clear channels with the channel UP/DOWN buttons, press the SKIP/
SEARCH buttons on the remote control unit until “SKIP MODE ON” is displayed on the bottom of
the screen. The TV will now tune only to strong active channels when the UP or DOWN buttons are
used on the monitor or remote control.
3. (B) To tune weak or marginal channels with the channel UP/DOWN buttons, press the SKIP/
the screen. Tune to the desired channel using the UP or DOWN buttons or go directly to the channel
by using the 0-9 buttons on the remote control.
4. To erase a channel, press the ERASE/WRITE buttons on the remote control unit until “MANUAL
MEMORY XX ERASE” is displayed on screen. To store a channel, press the buttons until the “
MANUAL MEMORY XX ADD” is displayed on screen.