User's Manual
Table Of Contents
- Table of Contents
- 1 | Introduction
- Back
- Front
- 2 | Getting Started
- STEP 1: Install the Battery
- STEP 2: Charge the Battery
- STEP 3: Set up your SoMo 655
- STEP 4: Install Synchronization Software on Host PC
- STEP 5: Connect to Host Computer
- STEP 6: Set Up Your Device Partnership
- Windows 7/Vista
- Windows XP/2000
- Register SoMo 655
- Install Microsoft Windows Mobile Updates
- Set up Enhanced Wi-Fi Companion
- Set up SocketScan 10
- Configure A/B Mode Switch
- Set up Connect!Agent
- Sprite Backup Trial
- MobiScan Rapid Configuration Tool
- Set up Data Capture Triggers
- Set up WAN Connections
- Configure CF/SD slots
- 3 | Using the SoMo 655
- 4 | Wi-Fi Companion
- 5 | Socketscan 10 for CHS Series 7 Barcode Scanners
- 6 | Socketscan Plug-In for Scanners and Readers
- Appendix A
- Appendix B
- Appendix C
- Appendix E
- Appendix F
- Limited Warranty
- Disclaimer
- Limited Software Warranty
- Regulatory Compliance
26
3. Use the utility to configure your settings.
NEED NEW SCREEN SHOT THAT DOESN’T SAY
HOLD SWITCH
• Leave screen enabled: Select this checkbox to keep the screen on when the A/B Mode switch is activated.
A dialog will confirm the switch is activated. Tap OK or deactivate the switch to close the dialog.
When the SoMo is reset, this option is automatically re-enabled.
• Disable backlight: Select to keep the screen on but disable the backlight, recommended for conserving
battery life.
• Disable auto-suspend: Select to keep the SoMo alive when the hold switch is activated, regardless of
settings chosen in the Power applet.
Use this option with caution to avoid accidental battery depletion.
• Launch program when switch is activated/deactivated: Use the menu to select a program for the SoMo
to automatically launch when the hold switch is activated (in the down position, B) or deactivated (in the
up position, A).
4. After entering your settings, tap OK.