User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Socket Go Wi-Fi!
- Socket Wi-Fi Companion
- System Requirements
- Product Registration
- Useful Links
- 2 | Software Installation
- _
- 3 | Open or WEP-Enabled Networks
- 4 | WPA or 802.1x Networks
- 5 | Wi-Fi Companion
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Network Information
- _
- _
- Appendix D Troubleshooting
- _
- _
- Appendix E Technical Support
- _
CHAPTER 4: WPA OR 802.1X 25
STEP 3: Insert Go Wi-Fi! or Turn on WLAN Radio
If using Socket Go Wi-Fi!, insert the card into the slot of your Pocket PC.
Make sure the card is positioned correctly in the slot. In most cases, it
should be right-side up. Do not use excessive force, or damage may occur.
Note: To remove the SD card, press it into the slot. A spring will push the
card out. Do not remove the card by simply pulling, or damage may occur.
If using a WLAN radio built into your Pocket PC
, turn on the radio. Refer to
your Pocket PC manual for instructions.
Note: Your screen may vary from the one shown.