User's Manual
Table Of Contents
- Copyright Notice
- Table of Contents
- 1 | Introduction
- 2 | Setup for Windows Mobile
- 3 | Setup for Palm OS
- 4 | Setup for Windows 98SE/Me/2000/XP
- 5 | Setup for Windows XP Tablet Edition
- 6 | Setup for Mac OS X
- Appendix A Specifications
- Appendix B Network Information
- Appendix C Manual Dial-up Connection Setup
- Appendix D Advanced Software Installation
- Appendix E Faxing
- Appendix F Technical Support
- Limited Warranty
- Regulatory Compliance
METHOD 2: Dial Automatically from Your Application
The Pocket PC’s built-in Connection Manager automatically tries to
connect to your ISP or office network whenever you try to use a program
that uses a dial-up connection (e.g., email, Internet).
1. If you did not install Connect!Agent
, refer to the OPTIONAL section at
the end of this chapter to manually create a Bluetooth connection. Make
sure the Bluetooth radio of your Pocket PC is turned on.
2. Make sure the modem is turned on.
3. Start the program that uses a dial-up connection. Enter a request for data
transfer (e.g., in Internet Explorer, enter a URL and tap the green
arrow).
4. If you installed Connect!Agent, a bubble will appear reporting that the
modem is dialing. If desired, tap Hide to reveal a status screen reporting
that Connect!Agent is searching for the Cordless 56K Modem.
When prompted, enter the passkey from a sticker on the back on the modem.
Note: After a successful connection, Socket Connect!Agent will save the
device and passkey information, so future connections will be automatic.
20