User's Manual
Table Of Contents
- Copyright Notice
- Table of Contents
- 1 | Introduction
- 2 | Setup for Windows Mobile
- 3 | Setup for Palm OS
- 4 | Setup for Windows 98SE/Me/2000/XP
- 5 | Setup for Windows XP Tablet Edition
- 6 | Setup for Mac OS X
- Appendix A Specifications
- Appendix BNetwork Information
- Appendix CManual Dial-up Connection Setup
- Appendix DAdvanced Software Installation
- Appendix EFaxing
- Appendix FTechnical Support
- Limited Warranty
- Regulatory Compliance
OPTIONAL: Set up Advanced Networking
Follow the steps below to set up a connection for a RAS server. Advanced
setup is necessary only if your network does NOT use DHCP (Dynamic
Host Configuration Protocol).
Note: You may want to complete the Network Information Form in
Appendix B.
Windows XP
1. After completing the New Connection Wizard, the Connect screen will
appear. Click Properties.
2. Click on the Networking tab. Check Internet Protocol and click Properties.
3. Enter any necessary settings. If needed, click Advanced to enter DNS,
WNS or other settings. When done, click OK.
4. Click OK again in the main properties screen.
5. Restart your computer to make sure the changes take effect.
44