User Manual
Table Of Contents
- How this Manual is Organized
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Features
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Troubleshooting
- I cannot connect to a device in my folder.
- When I try to connect to my phone, I get a screen that says Partial Success.
- When I insert the Bluetooth Card, I get a message that says Unrecognized Card.
- My mobile computer cannot find any Bluetooth devices nearby.
- My mobile computer keeps powering down to protect memory contents.
- Appendix D Technical Support
- Limited Warranty
- Limited Software Warranty
- Copyright Notice
- Regulatory Compliance
CHAPTER 3 ADVANCED FEATURES | 15
Set up Your Bluetooth Card
Note: If you use the Get Connected! Wizard, which is recommended for
normal usage, then this step is not necessary. This step would be used to
change the friendly name of your mobile computer:
1. After you insert the Bluetooth Card, the Bluetooth icon
should
appear in the task tray (visible from the Today screen for Pocket PCs).
Tap on the icon.
2. In the pop-up menu, select Advanced Features, then My Bluetooth Device.
3. In the My Bluetooth Device screen, enter a Friendly Name and make any
desired configuration changes. When done, tap ok.
Note:
• In normal phone connect operation, Discoverable mode is not needed
and should be disabled.
• If you do enable Discoverable mode, the card will consume power.
To save power, remember to disable it when not needed.