User Manual
Table Of Contents
- How this Manual is Organized
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Advanced Features
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Troubleshooting
- I cannot connect to a device in my folder.
- When I try to connect to my phone, I get a screen that says Partial Success.
- When I insert the Bluetooth Card, I get a message that says Unrecognized Card.
- My mobile computer cannot find any Bluetooth devices nearby.
- My mobile computer keeps powering down to protect memory contents.
- Appendix D Technical Support
- Limited Warranty
- Limited Software Warranty
- Copyright Notice
- Regulatory Compliance
CHAPTER 2 BASIC SETUP | 7
Chapter 2 Basic Setup
This chapter covers the minimum steps you must complete to install and use
the Bluetooth Card.
STEP 1: Install the Software
Follow these steps BEFORE inserting the Bluetooth Card:
1. Make an active partnership between the mobile computer and a host PC.
An active partnership exists if data can be moved between the mobile
computer and the host PC via a serial/USB/Ethernet cable or cradle.
2. Insert the Socket Bluetooth Card Installation CD into the host PC.
3. Run the SETUP.EXE file on the CD-ROM. Do any of the following:
• Go to My Computer to access your CD drive and run the file.
• Use Windows Explorer to access your CD drive and run the file.
• Click Start then Run on the host PC. Type X:\SETUP.EXE
(Replace X with your CD drive letter.)
4. Follow the instructions on the host PC screen until installation is done.
Note: After completing setup, your host PC may display the following:
• An Application Downloading Complete. Click OK.
• A screen telling you to check your mobile device screen for extra
installation steps that may be necessary. Click OK.