User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | General Installation
- 3 | Dial-up Networking
- 4 | Bluetooth ActiveSync and LAN Access
- 5 | Socket OBEX
- 6 | Socket Dialer
- 7 | Bluetooth Serial Port
- 8 | Bluetooth Faxing and Printing
- 9 | My Device Manager
- 10 | Bluetooth Devices Folder
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Troubleshooting
- Appendix D Technical Support
- Limited Warranty
- Regulatory Compliance
3. If your mobile computer has fewer than 6 COM ports available, the
Disable IrDA? Screen will appear. If desired, disable IrDA to free
more ports. Tap Next>.
Note: This will disable the IR port on a mobile computer. To readjust
the IrDA settings, go to Start | Settings | System| IrDA. Some devices do
not allow you to disable IrDA.
4. In the next screen, choose the two ports and services that you plan to
use most often. After making your selections, tap Next>.
Note: You
cannot disable
the Bluetooth
Phone port.
5. In the last screen, read the instructions and tap Finish.
6. Soft reset your mobile computer by pressing the reset button. This is
necessary for changes to take effect.
Pocket PC 2003 only: Do not soft reset the device when a Socket card
is inserted, or errors may occur in application(s) using the card. If
errors occur, remove the card and soft reset the device. Wait for the
device reset to finish before you re-insert the card.
10 | CHAPTER 2: GENERAL INSTALLATION