User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Scanner Setup
- 3 | Setup for Windows PC
- 4 | Setup for Windows Mobile
- 5 | Setup for Apple
- 6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Barcode Label Specifications
- Appendix D Decode Zone
- Appendix E Command Barcodes for CHS 7C
- Appendix F Command Barcodes for CHS 7E, 7M, 7P, 7NRx
- Appendix G Special Button Sequences
- Appendix H CAB Installation
- Appendix I Connection Barcodes
- Appendix J Troubleshooting
- Appendix K Technical Support
- Limited Warranty
- SocketScan Software License Agreement
- Regulatory Compliance
24
Bluetooth
Stack
Connection Instructions
Toshiba
1. Double-click on the Bluetooth icon
in the system tray (notification area).
2. In Bluetooth Settings, click New Connection.
3. In the connection wizard, select Express Mode. Click Next. A device
search will begin.
4. In the device list, select Socket CHS [xxxxxx]. Click Next.
5. If a passkey is requested, enter 0000 (four zeroes). Click OK.
6. Follow the remaining screens to complete the wizard.
Broadcom
(Widcomm)
1. Click on the Bluetooth icon
in the system tray (notification area).
2. On the left side, under Bluetooth Tasks, click Add a Bluetooth Device. A
device search will begin.
3. In the device list, select Socket CHS [xxxxxx].
4. If a passkey is requested, enter 0000 (four zeroes). Click Pair Now.
5. If prompted to select a Bluetooth service, select the CHS and click Finish.
Use Bluetooth v2.1 or later for best results. Do not use Quick Connect |
Bluetooth serial devices when the CHS is in HID mode.
In the device search, the CHS will appear as Socket CHS [xxxxxx]. The characters in
brackets are the last six characters of the CHS Bluetooth Device Address (BDA),
which is labeled inside the battery compartment.
Only computers running Bluetooth 2.0 will prompt for a passkey.