User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Scanner Setup
- 3 | Setup for Windows PC
- 4 | Setup for Windows Mobile
- 5 | Setup for Apple
- 6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Barcode Label Specifications
- Appendix D Decode Zone
- Appendix E Command Barcodes for CHS 7C
- Appendix F Command Barcodes for CHS 7E, 7M, 7P, 7NRx
- Appendix G Special Button Sequences
- Appendix H CAB Installation
- Appendix I Connection Barcodes
- Appendix J Troubleshooting
- Appendix K Technical Support
- Limited Warranty
- SocketScan Software License Agreement
- Regulatory Compliance
32
7. Click on the Symbologies tab to modify which symbologies the CHS will be able to
decode.
Enabling all possible symbologies may slow the decoding process.
The RSS symbology is now known as GS1 DataBar.
If you want to read UPC-A symbols, disable the GS1 DataBar option so that GS1
DataBar symbols don’t get mistakenly decoded.
8. Click OK to exit the Scanner Properties. If desired, click Test to test scanning a barcode.
The Scan Window will appear.
9. Scan a barcode that you would like information about. The Scan Window will report the
barcode’s symbology, data length, and data, in your choice of ASCII or Hexadecimal
format.
10. After testing a barcode, click Close. Click OK to exit Scanner Settings. The CHS will beep
twice after disconnecting from Scanner Settings. A few seconds later, the CHS will beep
once after connecting to SocketScan 10.