User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Scanner Setup
- 3 | Setup for Windows PC
- 4 | Setup for Windows Mobile
- 5 | Setup for Apple
- 6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Barcode Label Specifications
- Appendix D Decode Zone
- Appendix E Command Barcodes for CHS 7C
- Appendix F Command Barcodes for CHS 7E, 7M, 7P, 7NRx
- Appendix G Special Button Sequences
- Appendix H CAB Installation
- Appendix I Connection Barcodes
- Appendix J Troubleshooting
- Appendix K Technical Support
- Limited Warranty
- SocketScan Software License Agreement
- Regulatory Compliance
CHAPTER 4: SETUP FOR WINDOWS MOBILE 43
Bluetooth
Stack
Connection Instructions
Microsoft
These
instructions
are based
on the
SoMo 650.
1. Tap Start
| Settings | Connections tab | Bluetooth. Tap Add new
device… Alternatively, you can tap Add at the bottom of the screen.
2. Follow the screens to pair with the CHS. In the list of found devices, tap
Socket CHS. If prompted for a passkey, enter 0000 (four zeroes).
3. In the Bluetooth Settings screen, tap on the COM Ports tab. Tap New
Outgoing Port.
4. Follow the screens to set up an outgoing COM port for the CHS.
5. Tap Start | Programs | SocketScan 10 folder | SocketScan 10 .
6. In the Today screen, tap on the SocketScan 10 icon in the task tray. In
the pop-up menu, tap SocketScan 10 Settings.
7. Make sure a COM port is selected. Tap ok.
8. Tap on the SocketScan 10 icon in the task tray. In the pop-up menu,
tap Socket EZ Pair.