User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Scanner Setup
- 3 | Setup for Windows PC
- 4 | Setup for Windows Mobile
- 5 | Setup for Apple
- 6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Barcode Label Specifications
- Appendix D Decode Zone
- Appendix E Command Barcodes for CHS 7C
- Appendix F Command Barcodes for CHS 7E, 7M, 7P, 7NRx
- Appendix G Special Button Sequences
- Appendix H CAB Installation
- Appendix I Connection Barcodes
- Appendix J Troubleshooting
- Appendix K Technical Support
- Limited Warranty
- SocketScan Software License Agreement
- Regulatory Compliance
56
3. In the device list, tap on Socket CHS (initially it will appear as Keyboard). Tap Pair.
In the device list, the CHS will appear as Keyboard, then as Socket CHS [xxxxxx]. The
characters in brackets are the last six characters of the CHS Bluetooth Device
Address (BDA), which is labeled inside the battery compartment.
4. The CHS will connect to the Apple device. If prompted, enter the passkey 0000 (four
zeroes).
The CHS will beep once when it has connected and is ready to scan barcodes.
The LED will also blink blue once every 3 seconds.
For iOS, the onscreen keyboard will automatically disappear within a few seconds
after the CHS connects, because the CHS is detected as a Bluetooth keyboard. To
open the onscreen keyboard while the iPad is connected to the CHS, see
instructions at the end of this chapter.