User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Scanner Setup
- 3 | Setup for Windows PC
- 4 | Setup for Windows Mobile
- 5 | Setup for Apple
- 6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Barcode Label Specifications
- Appendix D Decode Zone
- Appendix E Command Barcodes for CHS 7C
- Appendix F Command Barcodes for CHS 7E, 7M, 7P, 7NRx
- Appendix G Special Button Sequences
- Appendix H CAB Installation
- Appendix I Connection Barcodes
- Appendix J Troubleshooting
- Appendix K Technical Support
- Limited Warranty
- SocketScan Software License Agreement
- Regulatory Compliance
70
SCANNER SETTINGS (SPP MODE ONLY)
These special features only work when the CHS is connected to your Android
device.
Status Bar Icon
When SocketScan 10 is running, an icon that indicates the CHS connection status will appear at
the top of the screen.
CHS not connected CHS connected
To open Scanner Settings:
In the main screen of SocketScan 10, touch Scanner Settings.
The CHS will close SocketScan 10 Keyboard wedge, disconnect (indicated by 2
beeps (high-low)), open Scanner Settings and reconnect (indicated by a beep).
Basic Scanner Information
1. In the main screen of Scanner Settings, touch Socket CHS.
2. The screen will report the Bluetooth friendly name, scanner type, firmware
version, and battery level of your CHS. To change the Bluetooth friendly name,
touch Socket CHS.