User's Manual

CHAPTER 7: SETUP FOR BLACKBERRY 77
To scan barcodes:
1. Open your application. Place the cursor where you want to enter data.
2. Press the trigger button to scan a barcode. Make sure the aiming beam extends
across the entire width of the barcode.
For example, try scanning the following barcode:
After decoding the barcode and sending it to the tablet, by default the CHS
will beep once, the LED will flash green, and the aiming beam will turn off.
The CHS will also vibrate to indicate that the barcode is decoded. You can use
Command Barcodes
to modify the beep / LED / vibrate settings.
By default, a carriage return is applied after scanned barcode data is entered.
To disable the automatic carriage return, you can use the Command Barcodes
(use the Data Editing barcode for Data As Is).
If no data is read in a few seconds, the beam will turn off, and you must try
again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3
seconds, until the CHS beeps twice (high-low) and the blue LED turns off.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last tablet it paired
and connected to. Make sure your tablet is in range with Bluetooth enabled.
If the CHS is connected to your tablet and gets disconnected, it will try to reconnect for a
few minutes. Make sure the tablet is on and in range. If the CHS cannot reconnect, it will
give a long beep. Power off and on the CHS to restart the reconnection process.
See Appendix G for unpairing instructions.