User's Manual

CHAPTER 7: SETUP FOR BLACKBERRY 83
To scan barcodes:
1. Open your application. Place the cursor where you want to enter data.
2. Press the trigger button to scan a barcode. Make sure the aiming beam extends across
the entire width of the barcode.
For example, try scanning the following barcode:
IMPORTANT! Print out this page to scan the barcode. Do not scan it onscreen.
After decoding the barcode and sending it to the phone, by default the CHS will
beep once, the LED will flash green, and the aiming beam will turn off. The CHS
7NRx and 7P will also vibrate to indicate that the barcode is decoded. You can use
the Scanner Settings utility (see next page) or Command Barcodes
to modify the
beep / LED / vibrate settings.
To configure an automatic Carriage Return or Tab after each scan of data, use the
Scanner Settings utility (see next page) or Command Barcodes
.
If no data is read in a few seconds, the beam will turn off, and you must try again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds,
until the CHS beeps twice (high-low) and the blue LED turns off.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last phone it paired
and connected to. Make sure your phone is in range with Bluetooth enabled and
SocketScan 10 is running.
If the CHS is connected to your phone and gets disconnected, it will try to reconnect for a
few minutes. Make sure the phone is on and in range. If the CHS cannot reconnect, you will
hear a long beep. Press the trigger button to restart the reconnection process.
See Appendix G for unpairing instructions.