User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Scanner Setup
- 3 | Setup for Windows PC
- 4 | Setup for Windows Mobile
- 5 | Setup for Apple
- 6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Barcode Label Specifications
- Appendix D Decode Zone
- Appendix E Command Barcodes for CHS 7C
- Appendix F Command Barcodes for CHS 7E, 7M, 7P, 7NRx
- Appendix G Special Button Sequences
- Appendix H CAB Installation
- Appendix I Connection Barcodes
- Appendix J Troubleshooting
- Appendix K Technical Support
- Limited Warranty
- SocketScan Software License Agreement
- Regulatory Compliance
APPENDIX E: COMMAND BARCODES FOR CHS 7C 97
Factory Defaults
Factory Reset
Configures the CHS 7C to revert all settings to factory defaults. The CHS will
power off after scanning this barcode.
Data Editing – Suffix
Data As Is (default)
Configures the CHS to
return only the decoded
data (i.e., prefix and
suffix are not sent).
Suffix – Carriage
Return
Configures the CHS to
add a carriage return at
the end of decoded data.
Suffix – Line Feed
Configures the CHS to
add a line feed at the
end of decoded data.
Suffix – Carriage
Return & Line Feed
Configures the CHS to
add a tab and carriage
return at the end of
decoded data.
Power Button Double Press Key Combination
Scan to Enable WITH BEEP Description Scan to Enable WITHOUT BEEP
CTRL + Z
CTRL + A
SHIFT + TAB
CTRL + S