User's Manual

52
By default, a carriage return is applied after scanned barcode data is entered. To
disable the automatic carriage return, you can use the Command Barcodes
(use
theData Editing barcode for Data As Is).
If no data is read in a few seconds, the beam will turn off, and you must try
again.
Watch a video: http://www.youtube.com/user/socketmobile#p/a/u/0/eZqb99pAbEc
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds,
until the CHS beeps twice (high-low) and the blue LED turns off.
After the iPad disconnects from the CHS, the soft keyboard will automatically
reappear within a few seconds.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last computer it
paired and connected to. Make sure your computer is in range with Bluetooth enabled.
If the CHS is connected to your computer and gets disconnected, it will try to reconnect.
Make sure the computer is on and in range. If the CHS cannot reconnect after several
attempts, it will emit a long beep. Press the trigger button to restart the reconnection
process.
See Appendix F for unpairing instructions.
Simultaneous Scanning and Soft Keyboard Support:
Revisions G and later of the CHS 7X and 7XRx and all revisions of the 7Xi and 7XiRx
support simultaneous use of the barcode scanner and the onscreen keyboard while
entering data into an application. This feature is enabled by default and can be modified
by scanning a special command barcode.
1. Connect the CHS to your Apple device.
2. Open your application and place the cursor where you want to enter data.
3. You can begin scanning barcodes. To open or close the onscreen keyboard, quickly
double-press the CHS power button (like double-clicking a mouse).
After you double-press the power button, the CHS will beep to indicate that the
onscreen keyboard was enabled / disabled.
Watch a video: http://www.youtube.com/watch?v=VhtttoC6ROs