User's Manual

78
6. Power on the CHS. Press and hold the small power button until the LED turns
blue and the CHS beeps twice (low-high).
The LED blinks blue once per second to show that the Bluetooth radio is
on but not connected.
7. Scan the barcode that appears on the screen. The CHS will beep three times.
8. When asked if you want to connect to the CHS, click Yes.
The CHS will be referred to as Socket CHS 7x [xxxxxx] for the 7X / 7XRx or
Socket 7Xi [xxxxxx] for the 7Xi / 7XiRx. The characters in brackets are the
last six characters of the CHS Bluetooth Device Address (BDA), which is
labeled inside the battery compartment.
9. If prompted for a passkey, enter 0000 (four zeroes),
Only phones running Bluetooth 2.0 will prompt for a passkey.
The CHS will beep once after it has connected and is ready to scan
barcodes. The LED will also blink blue once every 3 seconds.
10. Close Socket EZ Pair. Click Menu | Close.
SocketScan 10 will report the Bluetooth name of the CHS you are
connected to.