User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
Scanning Distance
• The optimal scanning distance varies depending on the bar code size,
symbology, label media, W-N Ratio, and scan angle. In general, the
CRS can successfully scan 2.2 to 30+ inches from the bar code.
• The larger the bar code, the further away you should position the
scanner.
• The tighter the bars of the bar code, the closer you should position the
scanner.
About the Cable Break Away
The CRS is designed to break away from the hand if subjected to unusual
force. This break away feature is designed to reduce the possibility or extent
of injury to the body in the event the CRS becomes entangled in industrial
equipment.
If the cable breaks away from the ring scanner unit during use, simply,
simply plug it back in to resume operation.
Note: Whenever the cable disconnects from the ring scanner, it will beep 3
times.
CHAPTER 1: INTRODUCTION 11