User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
Hardware and Software Indicators
Ring Scanner LED
LED LED Activity Meaning
Good Read Green Data successfully scanned and sent to host device
Wrist Unit LEDs
LED LED Activity Meaning
Blinking blue
every second
Bluetooth radio is on, no connection
Bluetooth Status
Blinking blue,
every 5 seconds
Bluetooth connection
Blinking Red 20% battery capacity remaining
Solid Red 10% battery capacity remaining
Battery Status
Off Off or Good Battery status
Wrist Unit Beeps
Beep Pattern Meaning
1 beep Bluetooth connection to host device has begun or power on
2 beeps Bluetooth connection to host device has ended or power off
1 beep (optional setting) Data successfully scanned and sent to host device
3 beeps Cable disconnected from wrist unit
SocketScan Icon Bottom of Today screen when SocketScan is open. Tap for menu.
Icon Meaning
The CRS is not connected to the host device
The CRS is connected to the host device
Note: In the SocketScan software, the abbreviation “CS” stands for “cordless
scanner” and applies to both the Socket Cordless Ring Scanner and Socket
Cordless Hand Scanner.
CHAPTER 1: INTRODUCTION 9