User's Manual

8. Regulatory Compliance

8.1 English

Go Wi-Fi! cards are designed to be compliant with the rules and regulations in locations

where they are sold and will be labeled as required. This product is type approved and

users are not required to obtain license or authorization before using.

USA

• FCC Part 15 Subpart B Class B Section 15.107, 15.109

• FCC Part 15 Subpart C Section 15.207, 15.247

• FCC Part 15 Subpart E Section 15.207, 15.209, 15.407

• FCC Procedure ANSI C63.4 (2003)

• FCC SAR OET65

Canada

• IC RSS-210

Europe

• CE EN 300 328, EN 301 489, EN 301 893, EN 62311, EN 60950

• Emissions Compliance: CE SAR Gap: 1 cm

Japan

• TELEC STD-T33, STD-T66, STD-T71 (W52, W53, W56)

This product is in compliance with the EU Directive 2002/95/EC for Restriction of

Hazardous Substances (RoHS).

8.1.1 Federal Communications Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equipment.

This equipment complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause

undesired operation.