User Manual

CHAPTER 4: CONNECT!AGENT 25
3. Enter the following settings:
• Enable CS support: Check this box. IMPORTANT!!!
• Enable ActivePairing: Uncheck.
• Bluetooth stack: Select Socket Connect!Agent.
• CS trigger operation: Select whether you want the CHS/CRS
to scan only when a Bluetooth connection to the device is
detected. If you select Scan only when connected to host,
scanning will be a few milliseconds slower (Error Proof Protocol
will be enabled).
• Good read indication on CS: Select how you would like the
CHS/CRS to indicate that it has successfully read data.
• Auto re-connect: Select the maximum number of tries and
time limit for the CHS/CRS to try to reconnect to your computer
in case they move out of range.