User's Manual

13
BUTTONS (CONT.)
DISINFECT
CYCLE
Starts the disinfection process with a single push.
NOTE: Your CPAP mask and hose must be
present in the SoClean 3 with the Lid closed to
operate the Disinfect Cycle.
A
Used to set a 2, 4, or 6 hour delay to the start
of your Disinfect Cycle.
Set delay by pressing once for 2 hours, twice
for 4 hours, three times for 6 hours and four
times to turn the Delay feature o.
NOTE: For your convenience, the system
automatically defaults to the Cycle Delay that
was last run. If the Cycle Delay was not used,
the system will default to a 2-hour delay.
CYCLE
DELAY
B
FRESH AIR
CYCLE
C
Runs air through the system to freshen your
equipment with the push of a button.
NOTE: The Fresh Air Cycle does not disinfect
your CPAP equipment.
NOTE: Your CPAP mask and hose must be
present in the SoClean 3 with the Lid closed
to operate the Fresh Air Cycle.
LID OPEN
D
Opens the Lid when the device is connected to
power. This button can also be used to cancel an
active Disinfect Cycle by pressing and holding
for 5 seconds.
INTRODUCING YOUR SOCLEAN 3
NOTE: If canceling a cycle, Lid cannot be
opened until Cycle Complete Icon illuminates.
(See page 40)
A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 13A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 13 7/2/20 5:26 PM7/2/20 5:26 PM