User's Manual

20
Remove the Original Lid from
the CPAP reservoir base by
opening the Original Lid fully,
pushing one side of the hinge
tab outward and freeing the
Original Lid from the base.
Save the Original Lid in case it is needed in the future.
Install the Reservoir Lid
Adapter to the reservoir
base by inserting the hinge
pins into the notches on the
reservoir base. If needed insert
one hinge pin at a time and
gently ex the Reservoir Lid
Adapter to snap it in place.
NOTE: CPAP shown is for
representation purposes to
illustrate a Reservoir Lid
Adapter.
1
2
Original Lid
ADAPTER CONNECTION:
Reservoir Lid Adapter
Reservoir
Lid Adapter
Hinge Tab
Hinge Pin
A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 20A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 20 7/2/20 5:26 PM7/2/20 5:26 PM