User's Manual

Plug the Power Adapter

into an AC wall outlet or

power strip.

Plug the Power Adapter

into the back of your

SoClean 3 as shown.

NOTE: Your SoClean 3 does not have a power switch to turn the device on/

o. When initially connected to power, the lights on your SoClean 3 will ash a

pattern (you may not see this if not looking at the device immediately after it is

connected to power). The SoClean 3 enters a low-power “sleep” mode when not

in use and fully powers when you press any of the buttons on the Control Panel.

At this point in your SoClean 3 set

up, your Control Panel should

appear as shown.

NOTE: The Filter Issue and Hose Not

Detected icons are illuminated on your

Control Panel because the Filter is not

yet installed and the CPAP mask/hose

has not been placed into the SoClean

3 with the Lid closed.

Power Adapter

NOTE: Position the the SoClean

3 so that it is easy to operate and

disconnect from power.

A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 28A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 28 7/2/20 5:26 PM7/2/20 5:26 PM