User's Manual

34
DISINFECT CYCLE
The SoClean 3 can be used daily to disinfect your CPAP equipment in
approximately 1 hour with the Disinfect Cycle.
CAUTION: The SoClean 3 device will not operate without the mask and hose
present in the securely closed Chamber. Additionally, the SoClean 3 will not
operate if the CPAP hose or Filter is not present with the Filter Door closed.
WARNING: In the event of loss of power to your home or the SoClean 3 device,
you will need to rerun the entire Disinfect Cycle to make sure your CPAP equip-
ment has been properly disinfected.
STEP 1: Press the Lid Open button
to open the lid.
NOTE: The Lid will spring open and blue
light will illuminate from the inside of the
bottom of the Disinfection Chamber.
The buttons on the Control Panel
will illuminate blue and the Hose Not
Detected icon will illuminate amber
since there is no CPAP mask or hose
installed in the device.
STEP 2: Place your CPAP mask into
the Disinfection Chamber and route
the CPAP hose through the Hose Slot.
CAUTION: Ensure your mask is resting
on the bottom of the Disinfection
Chamber and that the flexible ridged
CPAP hose, not the rigid rubber
connector, is in the Hose Slot.
HOSE
SLOT
Using Your SoClean 3
Once you have completed the set up steps, you are ready to begin
the daily disinfection of your CPAP equipment with your SoClean 3.
A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 34A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 34 7/2/20 5:26 PM7/2/20 5:26 PM