User's Manual

35
USING YOUR SOCLEAN 3
STEP 3: Push the Lid down until it
latches shut.
NOTE: With your CPAP mask and hose
properly installed and the Lid closed, the
system defaults to a 2-hour cycle start
delay, or the last Cycle Delay programmed.
The buttons will illuminate blue for a few
seconds and the Cycle Delay button will
show the programmed delay.
STEP 4: To run the Disinfect Cycle
immediately, press the Disinfect
Cycle button to start. This overrides
the Cycle Delay.
NOTE: You should hear the ozone
generator and air pump start when
the Disinfect Cycle starts.
NOTE: The Disinfect Cycle button will
illuminate blue to indicate the Disinfect
Cycle is operating. The Progress Bar
on the Control Panel will illuminate blue
from left to right as the cycle proceeds
to completion.
NOTE: If you need to remove your CPAP equipment before the Disinfect Cycle
is complete, see page 30 “Canceling a Cycle” section.

No delay





2-hr delay selected (default)



4-hr delay selected

 6-hr delay selected
NOTE: The ozone generator and air pump
will stop running after approximately
7 minutes. It is important to leave your
CPAP mask and hose in the SoClean 3 for
the complete one-hour duration to ensure
full disinfection of your CPAP equipment.
The SoClean will operate the air pump and circulating fan for the last 5 minutes
of the 1-hour cycle duration to move fresh air through the system.
A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 35A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 35 7/2/20 5:26 PM7/2/20 5:26 PM