User's Manual

40
CANCELING A CYCLE
If you need to remove your CPAP equipment while an active Disinfect Cycle
is taking place you can cancel the cycle.
During the Disinfect Cycle cancellation, the
Fault/Unable to Run icon will illuminate
red, indicating the Lid is locked and the
Cycle Start button will illuminate blue.
The Progress Bar on the Control Panel
will ash blue while the cycle cancellation
is in progress.
STEP 1: Press and hold the Lid Open
button for approximately 5 Seconds.
NOTE: You can cancel the Disinfect Cycle at
any time, regardless of where your SoClean
3 is in the process of disinfection.
The SoClean 3 will pump air through
the system for approximately 6 minutes
after the Disinfect Cycle is cancelled in
order to clear ozone from your CPAP
equipment.
USING YOUR SOCLEAN 3
STEP 2: At the end of the Disinfect Cycle
cancellation, the Cycle Complete icon
will light up green. The Disinfect Cycle
was successfully cancelled. You can now
press the Lid Open button and remove
your mask.
Your CPAP equipment may not have been
fully disinfected, but it is available for use!
A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 40A000482-11_Rev A-SC3 Manual-Setup_US-070220.indd 40 7/2/20 5:26 PM7/2/20 5:26 PM