User's Manual

POSSIBLE CAUSES SOLUTIONS

The Lid is locked during a

Cycle. To cancel the cycle,

press the Lid Open button for

approximately 5 seconds. The

cancellation will not happen

immediately. The system needs

time to purge the ozone from the

Chamber. The Cycle Complete

icon will illuminate green

signaling that the Lid can now

be opened.

The Cycle is running.

The Lid may be stuck. Be sure to release the button

once you hear the click.

Your device is pumping air through

the system to remove ozone and

allow you to access your items.

Allow this Cycle to complete. You

can then either remove your items

for use or start a new Cycle.

Your device was operating a

Cycle and one of the following

occurred:

• Power to the device was

momentarily lost

• Lid was forced opened

• Internal device Issue

GENERAL TROUBLESHOOTING

Indicates the Cycle has

been canceled.

The Progress Bar on the Control

Panel will flash blue until the

cycle cancellation progress is

complete.

A000867-11 Rev B_SDD-Manual-070720_ASC.indd 21A000867-11 Rev B_SDD-Manual-070720_ASC.indd 21 7/7/20 10:30 AM7/7/20 10:30 AM