Use and Care Manual

Enjoy your sparkling water or add your preferred SodaStream Sparkling Drink Mix flavor
to enjoy a sparkling flavored beverage!
For sparkling drink mixes: After making sparkling water hold the open carbonating
bottle at an angle and slowly add the desired flavor by pouring it slowly and carefully
down the inside wall of the bottle. Close with the fizz-preserving cap and tighten, then
mix with a gentle shake. Enjoy!
ONLY CARBONATE WATER .
NEVER CARBONATE AFTER FLAVOR HAS BEEN ADDED.
4. After inserting the bottle into the Snap-Lock press any of the carbonating buttons
and all the buttons will light up showing that they are active. When all the buttons
are lit, press the button for your desired carbonation level. The pressed button will
start to flash slowly indicating that it is carbonating. The button will flash quickly
when carbonation is complete. You may carbonate again without removing the
carbonating bottle by repeating the process. Pressing any button during
carbonation will stop the carbonation process. When the desired level of
carbonation is achieved, gently pull the carbonating bottle towards you until it
reaches its fully forward position. This will release all the pressure in the bottle and
allow the bottle to release itself from the Snap-Lock. Never pull the bottle out of the
Snap-Lock: always allow the bottle to release itself. If the carbonating bottle does
not immediately release from the Snap-Lock wait a few moments and it may
release. If it still does not release, then push the bottle back into the vertical position
and repeat the process.
WARNING: DO NOT remove the bottle until you hear the sound of excess CO
2
releasing.
Sparkling Drink Mix Enjoy!
FLAVOR YOUR WAY!
CREATE THE BUBBLES