Operation Manual

EN
27
PRIOR TO THE FIRST MEASUREMENT
Setting date, time, and
unit of measure
Date and time must be set prior
to using the blood pressure mon-
itor so that every measurement
value that is stored can be time
stamped.
1. If the device is switched off,
push the key (
) to display the
time. Then push and hold the
key (
) to set the year.
2. Push the key (
) to change the
[YEAR]. Each time you push the
key, the year increases by one.
3. Once the year has been set,
push key (
) to save the infor-
mation and continue.
4. Repeat steps 2 and 3 to set
[MONTH], [DAY], [HOUR], [MIN-
UTE] and [UNIT OF MEASURE]
You can switch between the unit of measure
“kPA” (kilo pascal) or “mmHg” (millimetre
mercury column), where mmHg is the most
common unit for measuring blood pressure.
5. After setting the unit of measure,
the LCD display shows “done”
and then displays all settings
entered by you before switching
off.
Selecting the user
A total of two users can be
programmed. 60 datasets can be
stored for each user.
1. If the device is switched off,
push and hold the key (
) to
select the user. The user symbol
(
) flashes.
2. Push key (
) again to select
between user 1, 2 or “Guest”
(guest mode).
The measurements are not stored or trans-
mitted in guest mode.
3. Confirm the selection of the
respective user by pushing (
).
The respective user and “done”
are shown before the display
switches off.
Soehnle Connect app
To use all functions of your
Systo Monitor Connect 300, we
recommend that you connect the
device to the Soehnle Connect
app prior to first use.
1. Download and install the free
Soehnle Connect app on your
smartphone or tablet. Scan
the QR code to access the app