Operation Manual

EN
30
DATA MANAGEMENT
Recalling stored values
1. Push ( ) to switch the blood
pressure monitor on. The
average value of the last three
datasets will be displayed.
2. Push the key (
) or ( ) to get
to the desired datasets. While
scrolling, the number of the
displayed dataset and the total
number of stored measure-
ments will be shown in the
upper right corner.
If you leave a dataset displayed, date and
time of the measurement will also be
shown. They will be put through automat
-
ically.
3. If you would like to recall the
datasets of another user, first
push the key (
) to switch
the device off if the blood pres-
sure monitor is still in the “recall
memory” mode.
Push and hold the key ( ) to
enter the mode “select user”,
push the key (
) again to select
between user 1 and user 2. Push
the key (
) to confirm the
user, then recall the measured
datasets of the selected user
with (
).
The most current dataset (1) is shown rst.
Each new measurement is stored at dataset
(1). All other datasets are moved back by
one (2 becomes 3, etc.) and the last dataset
(60) is removed from the list.
Deleting stored values
If a measurement is not perfor-
med correctly, you can delete
all measurement results for the
selected user as follows.
1. Push and hold key ( ) for
approximately 3 seconds while
the blood pressure monitor is
in the “recall memory” mode.
“dEL ALL” (delete ALL) will flash
and the selected user will be
displayed.
Push (
) to exit the “delete” mode wi
-
thout deleting datasets.
2. Push ( ) to confirm deletion,
and “user+dEL done” will be
displayed. The blood pressure
monitor then switches off
automatically.