User Guide

ENGLISH

Power-on

Only when the scale is not loaded.

After the test routine, the display is set to zero.

The scale is ready for use.

Place the weighing product on the scale.

The display shows the gross weight.

The measured values stabilise after a short warm-up peri-

od of 15 minutes after power-on. Place the weighing pro-

duct carefully on the scale. Do not keep any loads perma-

nently on the platform.

Avoid shocks and loading the scale beyond specified

maximum load.

These could damage the scale.

Setting the backlighting mode

Press the key.

The function toggles between the operating states > Off >

Active in weighing mode > Continuous mode.

If the backlight is continuous mode, the scales only

approx. 30% of the possible battery service time.

Zero

If zero is not indicated when the scale is unloaded, press

the key.

Possible zero range -2 % ... +2 % of the weighing range.

Tare weighing

Place a container on the platform and press the

key.

The display is reset to zero and Net is displayed.

Place the weighing product on the scale. After the display

settles, the net weight of the weighing product is display-

ed.

Clear tare: when the scale is empty, press the key.

Totalising

Weight values > min. area or piece number can be stored

in the total memory by pressing the key. Max. 9999

totalising operations are possible, but only up to a six-digit

value. The M+ symbol is displayed after the first totalising

operation. To perform further totalising operations, empty

the scale, place the next weight on the scale and press

the key again. Press to display the total. The

number of totalising operations appears first, followed by

the value.

Clear total: press the and keys one after another.

On/Off switch

bottom left

9320

BA_9320_D_GB_F_E_I.qxd 17.03.2006 15:55 Seite 13